Date: Thu, 7 Jun 2001 16:17:32 -0400 From: Graham Dunn <gdunn@inscriber.com> To: Cameron Grant <gandalf@vilnya.demon.co.uk> Cc: freebsd-stable@FreeBSD.ORG Subject: Re: CS4232 with pcm driver returns device_probe_and_attach: pcm0 attach returned 6 Message-ID: <20010607161729.A61368@inscriber.com> In-Reply-To: <009401c0ef6b$bed05f80$0504020a@haveblue>; from gandalf@vilnya.demon.co.uk on Thu, Jun 07, 2001 at 05:04:40PM %2B0100 References: <20010607115436.E30441@inscriber.com> <009401c0ef6b$bed05f80$0504020a@haveblue>
next in thread | previous in thread | raw e-mail | index | archive | help
If I specify device pcm0 at isa? port 0x534 irq 7 I get: mss_detect, busy still set (0xff) pcm0 failed to probe at port 0x534-0x53b irq 7 on isa0 with device pcm0 at isa? port? irq? drq1 flags 0x15 [snip] avail memory = 77828096 (76004K bytes) bios32: Found BIOS32 Service Directory header at 0xc00f8dc0 bios32: Entry = 0xfe95b (c00fe95b) Rev = 0 Len = 1 pcibios: PCI BIOS entry at 0xde53 pnpbios: Bad PnP BIOS data checksum Other BIOS signatures found: ACPI: 00000000 Preloaded elf kernel "kernel" at 0xc03c7000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc03c70a8. Intel Pentium detected, installing workaround for F00F bug md0: Malloc disk Creating DISK md0 Math emulator present pci_open(1): mode 1 addr port (0x0cf8) is 0x80001850 pci_open(1a): mode1res=0x80000000 (0x80000000) pci_cfgcheck: device 0 [class=060000] [hdr=00] is there (id=06011179) apm0: <APM BIOS> on motherboard apm: found APM BIOS v1.1, connected at v1.1 npx0: <math processor> on motherboard npx0: INT 16 interface i586_bzero() bandwidth = 131233595 bytes/sec bzero() bandwidth = 195045835 bytes/sec pci_open(1): mode 1 addr port (0x0cf8) is 0x00000000 pci_open(1a): mode1res=0x80000000 (0x80000000) pci_cfgcheck: device 0 [class=060000] [hdr=00] is there (id=06011179) pcib0: <Host to PCI bridge> on motherboard found-> vendor=0x1179, dev=0x0601, revid=0x11 class=06-00-00, hdrtype=0x00, mfdev=0 subordinatebus=0 secondarybus=0 found-> vendor=0x102c, dev=0x00e0, revid=0x04 class=03-00-00, hdrtype=0x00, mfdev=0 subordinatebus=0 secondarybus=0 map[10]: type 1, range 32, base fe000000, size 24 pci0: <PCI bus> on pcib0 pci0: <Chips & Technologies 65550 SVGA controller> (vendor=0x102c, dev=0x00e0) at 4.0 isa0: <ISA bus> on motherboard Trying Read_Port at 203 Trying Read_Port at 243 Trying Read_Port at 283 Trying Read_Port at 2c3 Trying Read_Port at 303 Trying Read_Port at 343 Trying Read_Port at 383 Trying Read_Port at 3c3 isa_probe_children: disabling PnP devices isa_probe_children: probing non-PnP devices fdc0: <NEC 765 or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fd0: <1440-KB 3.5" drive> on fdc0 drive 0 ata0: iobase=0x01f0 altiobase=0x03f6 bmaddr=0x0000 ata0: mask=03 status0=50 status1=00 ata0: mask=03 ostat0=50 ostat2=00 ata0-master: ATAPI probe a=00 b=00 ata0-slave: ATAPI probe a=00 b=00 ata0: mask=03 status0=50 status1=00 ata0-master: ATA probe a=01 b=a5 ata0: devices=01 ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0 ata1: iobase=0x0170 altiobase=0x0376 bmaddr=0x0000 ata1: mask=03 status0=50 status1=00 ata1: mask=03 ostat0=50 ostat2=00 ata1-master: ATAPI probe a=14 b=eb ata1-slave: ATAPI probe a=14 b=eb ata1: mask=03 status0=00 status1=00 ata1: devices=0c ata1 at port 0x170-0x177,0x376 irq 15 on isa0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 atkbd: the current kbd controller command byte 0047 atkbd: keyboard ID 0x41ab (2) kbd0 at atkbd0 kbd0: atkbd0, AT 101/102 (2), config:0x1, flags:0x3d0000 psm0: current command byte:0047 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model GlidePoint, device ID 0-00, 2 buttons psm0: config:00000000, flags:00000000, packet size:3 psm0: syncmask:c0, syncbits:00 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 fb0: vga0, vga, type:VGA (5), flags:0x7007f fb0: port:0x3c0-0x3df, crtc:0x3d4, mem:0xa0000 0x20000 fb0: init mode:24, bios mode:3, current mode:24 fb0: window:0xc00b8000 size:32k gran:32k, buf:0 size:32k VGA parameters upon power-up 50 18 10 00 00 01 03 00 02 67 5f 4f 50 82 55 81 bf 1f 00 4f 0d 0e 00 00 05 f0 9c 0e 8f 28 1f 96 b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c 3d 3e 3f 0c 00 0f 00 00 00 00 00 00 10 0e 00 ff VGA parameters in BIOS for mode 24 50 18 10 00 10 00 03 00 02 67 5f 4f 50 82 55 81 bf 1f 00 4f 0d 0e 00 00 00 00 9c 8e 8f 28 1f 96 b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c 3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff EGA/VGA parameters to be used for mode 24 50 18 10 00 00 01 03 00 02 67 5f 4f 50 82 55 81 bf 1f 00 4f 0d 0e 00 00 05 f0 9c 0e 8f 28 1f 96 b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c 3d 3e 3f 0c 00 0f 00 00 00 00 00 00 10 0e 00 ff sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sc0: fb0, kbd0, terminal emulator: sc (syscons terminal) mss_probe: no address given, try 0x530 mss_detect - chip revision 0x0a mss_detect() - Detected CS4232 pcm0: <CS4232> at port 0x530-0x537 drq 1 flags 0xa115 on isa0 device_probe_and_attach: pcm0 attach returned 6 pcic0: <Intel i82365> at port 0x3e0 iomem 0xd0000 on isa0 pcic0: Polling mode stat is fe stat is f2 pccard0: <PC Card bus -- kludge version> on pcic0 pccard1: <PC Card bus -- kludge version> on pcic0 pcic1: not probed (disabled) sio0: configured irq 4 not in bitmap of probed irqs 0 sio0: irq maps: 0x41 0x41 0x41 0x41 sio0: probe failed test(s): 0 1 2 4 6 7 9 sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 8250 sio1: irq maps: 0x41 0x49 0x41 0x41 sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A ie0 failed to probe at port 0x300 iomem 0xd0000 irq 10 on isa0 lnc0 failed to probe at port 0x280 irq 10 drq 0 on isa0 cs0 failed to probe at port 0x300-0x31f on isa0 sn0 failed to probe at port 0x300-0x30f irq 10 on isa0 isa_probe_children: probing PnP devices BIOS Geometries: 0:02e87f3f 0..744=745 cylinders, 0..127=128 heads, 1..63=63 sectors 0 accounted for Device configuration finished. bpf: ppp0 attached bpf: ppp1 attached new masks: bio 68c040, tty 63101a, net 67101a bpf: sl0 attached bpf: faith0 attached bpf: gif0 attached bpf: gif1 attached bpf: gif2 attached bpf: gif3 attached bpf: lo0 attached IPsec: Initialized Security Association Processing. IP Filter: v3.4.16 initialized. Default = pass all, Logging = enabled pccard: card inserted, slot 0 ata1-slave: ata_command: timeout waiting for intr ata1-slave: identify failed [snip] pciconf -l shows: chip0@pci0:0:0: class=0x060000 card=0x00000000 chip=0x06011179 rev=0x11 hdr=0x00 none0@pci0:4:0: class=0x030000 card=0x00000000 chip=0x00e0102c rev=0x04 hdr=0x00 pnpinfo: Checking for Plug-n-Play devices... No Plug-n-Play devices were found On Thu, Jun 07, 2001 at 05:04:40PM +0100, Cameron Grant wrote: > > Dmesg shows pcm detecting the card at 0x530 (BIOS says the card is at > > 0x534). Setting port 0x534 in the kernel config results in nothing being > > detected at all. > > some details (boot -v dmesg, pnpinfo, relevant bits of kernel config) would > be nice... > > -cg -- gdunn@inscriber.com Graham Dunn || ||| | ||| |||| | |||| | To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010607161729.A61368>