Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 29 Aug 2013 20:38:48 -0400
From:      George Mitchell <george+freebsd@m5p.com>
To:        Hans Petter Selasky <hps@bitfrost.no>
Cc:        freebsd-arm@freebsd.org, freebsd-current@freebsd.org
Subject:   Re: ulpt can't attach Lexmark E120
Message-ID:  <521FE998.6020402@m5p.com>
In-Reply-To: <5219C3FF.1070509@bitfrost.no>
References:  <5105527F.3010708@m5p.com> <201301271915.47712.hselasky@c2i.net> <510570C1.1060607@m5p.com> <201301272007.30682.hselasky@c2i.net> <5105AB16.2000607@m5p.com> <5215F4DF.6000305@m5p.com> <5215F743.8060403@bitfrost.no> <5216ACE5.7000500@m5p.com> <5216FE9F.2030608@bitfrost.no> <52174378.2020101@m5p.com> <521801E5.9000309@m5p.com> <52184F59.5080100@bitfrost.no> <5218F993.9050504@m5p.com> <5219C3FF.1070509@bitfrost.no>

next in thread | previous in thread | raw e-mail | index | archive | help
On 08/25/13 04:44, Hans Petter Selasky wrote:
> On 08/24/13 20:21, George Mitchell wrote:
>>
>> Setting hw.usb.dwc_otg.debug to any value greater than 0 generates an
>> unending stream of debug output and effectively locks up the chip
>> scrolling the output on the display.  Perhaps there are some specific
>> debug messages I could put in ...                           -- George
>
> Hi,
>
> Can you try this patch:
>
> http://svnweb.freebsd.org/changeset/base/254828
>
> --HPS
> _______________________________________________
> freebsd-current@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"

Finally my RPi build system is working again and I can happily report
that my Lexmark printer attaches successfully!  Thank you!  (And I
note the patch has been checked into the repository.)         -- George



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?521FE998.6020402>