Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 18 Oct 2001 23:58:49 -0400 (EDT)
From:      Wesley Morgan <morganw@chemikals.org>
To:        Trent Nelson <nelsont@switch.aust.com>
Cc:        freebsd-current@FreeBSD.ORG, <mobile@FreeBSD.ORG>
Subject:   Re: Accton EN2242 MiniPCI 10/100 (dc0) not working.
Message-ID:  <20011018235756.C84717-100000@volatile.chemikals.org>
In-Reply-To: <20011018151930.E23852@freebsd06.udt>

next in thread | previous in thread | raw e-mail | index | archive | help
My Xircom (cardbus) nic is nonfunctional in -current as well, however it
hangs the system when dhclient tries to set it up.

On Thu, 18 Oct 2001, Trent Nelson wrote:

>
>     I have a Sharp AR50 laptop.  It has an Accton EN2242 MiniPCI 10/100
>     NIC that's producing the following:
>
> pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
> dc0: <Accton EN2242 MiniPCI 10/100BaseTX> irq 11 at device 11.0 on pci0
> dc0: couldn't map ports/memory
> device_probe_and_attach: dc0 attach returned 6
>
>     I've read through the mailing lists and one other person reported
>     similar failure not quite on the same lines back in March 2000.
>     I don't have any PnP BIOS options -- so how long am I going to be
>     out of luck for?  What's actually required to get this working?
>
>     If I aquire a PCMCIA NIC in the interim, am I likely to have similar
>     problems?
>
>         Trent.
>
> % uname -a
> FreeBSD current.ar50.udt 5.0-CURRENT FreeBSD 5.0-CURRENT #1: Wed Oct 17 12:13:59 WST 2001 nelsont@current.ar50.udt:/usr/obj/usr/src/sys/current_17Oct2001 i386
>
> % pciconf -lv
> hostb0@pci0:0:0:        class=0x060000 card=0x00000000 chip=0x71908086 rev=0x03 hdr=0x00
>     vendor   = 'Intel Corporation'
>     device   = '82443BX/ZX 440BX/ZX AGPset Host Bridge'
>     class    = bridge
>     subclass = HOST-PCI
> pcib1@pci0:1:0: class=0x060400 card=0x00000000 chip=0x71918086 rev=0x03 hdr=0x01
>     vendor   = 'Intel Corporation'
>     device   = '82443BX/ZX 440BX/ZX AGPset PCI-to-PCI bridge'
>     class    = bridge
>     subclass = PCI-PCI
> isab0@pci0:7:0: class=0x068000 card=0x00000000 chip=0x71108086 rev=0x02 hdr=0x00
>     vendor   = 'Intel Corporation'
>     device   = '82371AB PIIX4 ISA Bridge'
>     class    = bridge
>     subclass = PCI-unknown
> atapci0@pci0:7:1:       class=0x010180 card=0x00000000 chip=0x71118086 rev=0x01 hdr=0x00
>     vendor   = 'Intel Corporation'
>     device   = '82371AB PIIX4 IDE Controller'
>     class    = mass storage
>     subclass = ATA
> none0@pci0:7:2: class=0x0c0300 card=0x00000000 chip=0x71128086 rev=0x01 hdr=0x00
>     vendor   = 'Intel Corporation'
>     device   = '82371AB PIIX4 USB Interface'
>     class    = serial bus
>     subclass = USB
> none1@pci0:7:3: class=0x068000 card=0x00000000 chip=0x71138086 rev=0x03 hdr=0x00    vendor   = 'Intel Corporation'
>     device   = '82371AB PIIX4 Power Management Controller'
>     class    = bridge
>     subclass = PCI-unknown
> none2@pci0:11:0:        class=0x020000 card=0x00121468 chip=0x12161113 rev=0x11 hdr=0x00
>     vendor   = 'Accton Technology Corporation'
>     class    = network
>     subclass = ethernet
> none3@pci0:12:0:        class=0x060700 card=0x101913bd chip=0xac42104c rev=0x00 hdr=0x02
>     vendor   = 'Texas Instruments'
>     device   = 'PCI4451 PC card CardBus Controller'
>     class    = bridge
>     subclass = PCI-CardBus
> none4@pci0:12:1:        class=0x060700 card=0x101913bd chip=0xac42104c rev=0x00 hdr=0x02
> none5@pci0:12:2:        class=0x0c0010 card=0x101913bd chip=0x8027104c rev=0x00 hdr=0x00
>     vendor   = 'Texas Instruments'
>     class    = serial bus
>     subclass = FireWire
> none6@pci0:14:0:        class=0x040100 card=0x101913bd chip=0x1988125d rev=0x12 hdr=0x00
>     vendor   = 'ESS Technology'
>     device   = 'ES1989 Allegro-1 Audiodrive'
>     class    = multimedia
>     subclass = audio
> none7@pci0:14:1:        class=0x078000 card=0x101913bd chip=0x1989125d rev=0x12 hdr=0x00
>     vendor   = 'ESS Technology'
>     device   = 'ES1989 Allegro-1.COMM ES56CVM-PI PCI Voice+Fax Modem'
>     class    = simple comms
> none8@pci1:0:0: class=0x030000 card=0x101913bd chip=0x4c4d1002 rev=0x64 hdr=0x00
>     vendor   = 'ATI Technologies'
>     device   = 'Rage P/M Mobility AGP 2x'
>     class    = display
>     subclass = VGA
>
> % dmesg
> Copyright (c) 1992-2001 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>         The Regents of the University of California. All rights
> reserved.
> FreeBSD 5.0-CURRENT #1: Wed Oct 17 12:13:59 WST 2001
>     nelsont@current.ar50.udt:/usr/obj/usr/src/sys/current_17Oct2001
> Timecounter "i8254"  frequency 1193182 Hz
> Timecounter "TSC"  frequency 846328227 Hz
> CPU: Pentium III/Pentium III Xeon/Celeron (846.33-MHz 686-class CPU)
>   Origin = "GenuineIntel"  Id = 0x686  Stepping = 6
>   Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PA
> T,PSE36,MMX,FXSR,SSE>
> real memory  = 268369920 (262080K bytes)
> avail memory = 256413696 (250404K bytes)
> Preloaded elf kernel "/boot/kernel/kernel" at 0xc03a8000.
> Pentium Pro MTRR support enabled
> Using $PIR table, 7 entries at 0xc00fdf50
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> pcib0: <Intel 82443BX (440 BX) host to PCI bridge> at pcibus 0 on motherboard
> pci0: <PCI bus> on pcib0
> pcib1: <PCI-PCI bridge> at device 1.0 on pci0
> pci1: <PCI bus> on pcib1
> pci1: <display, VGA> at device 0.0 (no driver attached)
> isab0: <PCI-ISA bridge> at device 7.0 on pci0
> isa0: <ISA bus> on isab0
> atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1 on pci0
> ata0: at 0x1f0 irq 14 on atapci0
> ata1: at 0x170 irq 15 on atapci0
> uhci0: <Intel 82371AB/EB (PIIX4) USB controller> irq 5 at device 7.2 on pci0
> uhci0: Could not map ports
> device_probe_and_attach: uhci0 attach returned 6
> pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
> dc0: <Accton EN2242 MiniPCI 10/100BaseTX> irq 11 at device 11.0 on pci0
> dc0: couldn't map ports/memory
> device_probe_and_attach: dc0 attach returned 6
> pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 12.0 on pci0
> pcic0: Could not map register memory
> device_probe_and_attach: pcic0 attach returned 12
> pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 12.1 on pci0
> pcic0: Could not map register memory
> device_probe_and_attach: pcic0 attach returned 12
> pci0: <serial bus, FireWire> at device 12.2 (no driver attached)
> pci0: <multimedia, audio> at device 14.0 (no driver attached)
> pci0: <simple comms> at device 14.1 (no driver attached)
> orm0: <Option ROMs> at iomem 0xc0000-0xcc7ff,0xe4000-0xe7fff on isa0
> atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
> atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
> kbd0 at atkbd0
> psm0: <PS/2 Mouse> irq 12 on atkbdc0
> psm0: model Generic PS/2 mouse, device ID 0
> fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
> ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
> ppc0: FIFO with 16/16/8 bytes threshold
> plip0: <PLIP network interface> on ppbus0
> lpt0: <Printer> on ppbus0
> lpt0: Interrupt-driven port
> ppi0: <Parallel I/O> on ppbus0
> sc0: <System console> at flags 0x100 on isa0
> sc0: VGA <16 virtual consoles, flags=0x300>
> sio0 at port 0x3f8-0x3ff irq 4 flags 0x80 on isa0
> sio0: type 16550A
> sio1: configured irq 3 not in bitmap of probed irqs 0
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> unknown: <PNP0303> can't assign resources
> unknown: <PNP0c02> can't assign resources
> unknown: <PNP0501> can't assign resources
> unknown: <PNP0f13> can't assign resources
> unknown: <PNP0401> can't assign resources
> unknown: <PNP0700> can't assign resources
> IP packet filtering initialized, divert enabled, rule-based forwarding enabled,
> default to accept, logging limited to 100 packets/entry by default
> Profiling kernel, textsize=1509504 [c01211c0..c0291a40]
> cputime 65, empty_loop 2, nullfunc_loop_profiled 167, mcount 228, mexitcount 157
> Profiling overheads: mcount: 62+163, 148+76; mexitcount: 62+92, 139+15 nsec
> Profiling overheads: mcount: 53+138, 126+65; mexitcount: 53+78, 118+13 cycles
> ata1-slave: ATAPI identify retries exceeded
> ad0: 19077MB <FUJITSU MHM2200AT> [38760/16/63] at ata0-master UDMA33
> acd0: DVD-ROM <UJDA540> at ata1-master PIO4
> Mounting root from ufs:/dev/ad0s3a
>
>
>

-- 
                                           _ __ ___ ____  ___ ___ ___
          Wesley N Morgan                       _ __ ___ | _ ) __|   \
          morganw@chemikals.org                     _ __ | _ \._ \ |) |
          FreeBSD: The Power To Serve                  _ |___/___/___/
          6bone: 3ffe:1ce3:7::b4ff:fe53:c297
Hi! I'm a .signature virus! Copy me into your ~/.signature to help me spread!


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20011018235756.C84717-100000>