Date: Tue, 16 Apr 2002 08:18:10 +0200 From: Wilko Bulte <wkb@freebie.xs4all.nl> To: "M. Warner Losh" <imp@village.org> Cc: scsi@FreeBSD.ORG Subject: Re: How to get 160MB/s LVD drives to use 160MB/s Message-ID: <20020416081810.A17224@freebie.xs4all.nl> In-Reply-To: <20020416.000750.89789192.imp@village.org>; from imp@village.org on Tue, Apr 16, 2002 at 12:07:50AM -0600 References: <20020416.000750.89789192.imp@village.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On Tue, Apr 16, 2002 at 12:07:50AM -0600, M. Warner Losh wrote: > I'm runing 4.5-release. From my dmesg: > > ahc0: <Adaptec 19160B Ultra160 SCSI adapter> port 0x9000-0x90ff mem 0xdf800000-0 > xdf800fff irq 11 at device 12.0 on pci0 > aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/255 SCBs > > da0 at ahc0 bus 0 target 0 lun 0 > da0: <IBM DGHS18Y CLAR18( 3C3C> Fixed Direct Access SCSI-3 device > da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled > da0: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C) > da1 at ahc0 bus 0 target 1 lun 0 > da1: <FUJITSU MAF3364L SUN36G 1213> Fixed Direct Access SCSI-2 device > da1: 40.000MB/s transfers (20.000MHz, offset 63, 16bit), Tagged Queueing Enabled > da1: 34732MB (71132959 512 byte sectors: 255H 63S/T 4427C) > > > Notice that I'm only getting 40MB/s transfers. The BIOS detects them > at 40MB/s, even though I have the max transfer set to 160. It does > this with one or two drives on the bus. They are SCA drives in > adapters (any chance it is a jumper on the adapter?). > > How do I get 160MB/s on these drives? As near as I can tell from the > spec sheets, they both should support 160MB/s. Are you sure you have LVD terminators at each end of the bus? And sufficiently short cable/bus length. U160 does something called domain verification (IIRC) to check if the bus is electrically sound enough to go high speed. -- | / o / /_ _ wilko@FreeBSD.org |/|/ / / /( (_) Bulte Arnhem, the Netherlands To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020416081810.A17224>