Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 27 Nov 2006 10:10:33 -0600
From:      Bruce Burden <brucegb@realtime.net>
To:        freebsd-stable@freebsd.org
Subject:   Re: Regarding Multiple RAID controller support with FreeBSD 4.11
Message-ID:  <20061127161033.GL937@tigerfish2.my.domain>
In-Reply-To: <35586460611270637q18567951y71f6eb6c3cad5836@mail.gmail.com>
References:  <35586460611270637q18567951y71f6eb6c3cad5836@mail.gmail.com>

next in thread | previous in thread | raw e-mail | index | archive | help
On Mon, Nov 27, 2006 at 08:07:13PM +0530, V.SriSaiGanesh Venkataramani wrote:
> 
> When i installed the system the root partition's slice was da0s1a. Now
> when i compiled the kernel with the support of LSI SAS driver, and i
> booted it, the LSI card first gets detected and the raw drives
> connected to LSI controller becomes da0, da1. Then my boot 6i gets
> detected and the LUN present in this conroller gets da2.
>
	You have the ability to specify the bus address in 4.x, I
    believe. There should be examples of it in GENREIC.

	I am not sure, but is ROOTDEVICE still required in 4.x? 
    If you have that specified, you can either try to change it to
    da2s1a, or comment it out and see if the kernel still compiles,
    and boots as expected once the controllers are identified.

							Bruce
-- 
------------------------------------------------------------------------
  "I like bad!"                         Bruce Burden    Austin, TX.
        - Thuganlitha
        The Power and the Prophet
        Robert Don Hughes




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20061127161033.GL937>