Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 15 Oct 2005 21:00:06 +0200
From:      Carl Gustavsson <cjgu@kth.se>
To:        freebsd-stable@freebsd.org
Subject:   Re: Boot manager problem
Message-ID:  <435151B6.5010805@kth.se>
In-Reply-To: <43514A9F.7000006@stud.ntnu.no>
References:  <43512F32.9050309@telia.com> <43514A9F.7000006@stud.ntnu.no>

next in thread | previous in thread | raw e-mail | index | archive | help
Owe Jørgensen wrote:

> I recently installed FreeBSD on a Compaq ProLiant 350 and I 
> experienced similar problems.
>
> I urge you to take a look into the BIOS/Firmware on the Motherboard. 
> There you will have an option called Boot Device Order.
> Make sure that the SCSI controller channel with that system disk is 
> set as the first boot device. Then you set up your OS to be of type 
> Other (in BIOS). Save and exit the BIOS. From now on, you stay away 
> from the BIOS.
>
> NOTE: You might want to disconnect ALL ide-disks (and CDROMs if you 
> have a SCSI cdrom) if you are reinstalling.
>
> Finish the installation, and power down. Reconnect all IDE-devices, 
> and boot up again. Continue to format and arrange the ide-drives as 
> desired.  Then install src distribution, recompile kernel and reboot.
>
> Good luck, and remember to drink a lot of coffee. ;-)
>
> Owe Jørgensen
> _______________________________________________
> freebsd-stable@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-stable
> To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"

Hi,

The problem is that there's not an option to select the scsi-controller 
as first boot device.  I can boot on the scsi-disc but only if i don't 
have any IDE-discs in it. If I put in IDE-discs it tries to boot to the 
first IDE-disc. The BIOS is very limited in the ProLiant 400.

FreeBSD is already installed on the machine and I don't need to 
reinstall it. The problem is only that it won't boot to the scsi disc if 
I dont write "1:da(0,a)/boot/loader" at the boot prompt every time i 
want to boot it. So I want the boot manager to boot to 
"1:da(0,a)/boot/loader" as default.

/ Carl Gustavsson



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?435151B6.5010805>