Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 25 Jul 2000 20:33:14 +0200
From:      Wilko Bulte <wkb@freebie.demon.nl>
To:        Andrew Gallatin <gallatin@cs.duke.edu>
Cc:        wilko@freebsd.org, FreeBSD-alpha mailing list <freebsd-alpha@freebsd.org>
Subject:   Re: presence of DEFPA (fddi) panics 4.1RC
Message-ID:  <20000725203314.B8155@freebie.demon.nl>
In-Reply-To: <14717.44106.43720.739368@grasshopper.cs.duke.edu>; from gallatin@cs.duke.edu on Tue, Jul 25, 2000 at 11:07:06AM -0400
References:  <20000725164548.A7231@freebie.demon.nl> <14717.44106.43720.739368@grasshopper.cs.duke.edu>

next in thread | previous in thread | raw e-mail | index | archive | help
On Tue, Jul 25, 2000 at 11:07:06AM -0400, Andrew Gallatin wrote:
> 
> Wilko Bulte writes:

>  > fatal kernel trap:
>  > 
>  >     trap entry = 0x2 (memory management fault)
>  >     a0         = 0x80821014
> 
> This is typically happens because  bus_alloc_resource(cfg->dev, SYS_RES_MEMORY,...)
> gives you an unusable address unless you specify if you want BWX or
> DENSE space.  
> 
> See if the following hack helps:
> 
> Index: pci/pci_compat.c
> ===================================================================
> RCS file: /home/ncvs/src/sys/pci/pci_compat.c,v
> retrieving revision 1.35
> diff -u -r1.35 pci_compat.c
> --- pci/pci_compat.c    2000/02/28 08:12:24     1.35
> +++ pci/pci_compat.c    2000/07/25 15:03:00
> @@ -96,7 +96,7 @@
>  
>         rid = reg;
>         res = bus_alloc_resource(cfg->dev, SYS_RES_MEMORY, &rid,
> -                                0, ~0, 1, RF_ACTIVE);
> +                                0, ~0, 1, RF_ACTIVE|PCI_RF_DENSE);
>         if (res) {
>                 *pa = rman_get_start(res);
>                 *va = (vm_offset_t) rman_get_virtual(res);
> 
> 
> I'm not sure if this is really correct.  But it will certainly rub off
> the sharp corners of some devices using the pci compat shims..

It does indeed polish the sharp edges. No panic anymore. I get a good probe
etc. But no link it seems. I'll doublecheck with T64 to see if the
link/cable etc is OK.

-- 
Wilko Bulte  	 			http://www.freebsd.org  
wilko@freebsd.org			http://www.nlfug.nl


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20000725203314.B8155>