Date: Thu, 1 Jan 2004 22:10:15 -0800 (PST) From: ctodd@chrismiller.com To: freebsd-bugs@FreeBSD.org Subject: Re: misc/60646: VIA C3 system hangs on reboot Message-ID: <200401020610.i026AFR8032311@freefall.freebsd.org>
next in thread | raw e-mail | index | archive | help
The following reply was made to PR misc/60646; it has been noted by GNATS. From: ctodd@chrismiller.com To: David Xu <davidxu@freebsd.org> Cc: Chris Miller <admin@forkthepenguin.com>, freebsd-gnats-submit@freebsd.org Subject: Re: misc/60646: VIA C3 system hangs on reboot Date: Thu, 1 Jan 2004 22:05:06 -0800 (PST) On Fri, 2 Jan 2004, David Xu wrote: > I have a VIA EPIA-M II board in hand, its chipset is VIA CLE266, runs > just fine, no the reboot problem you reported, I think it is not CPU > related, but chipsets or motherboard related, I saw your motherboard is > using SIS's chipsets... I recently spoke with someone with a VIA motherboard that said the same thing. The motherboard in question is an ECS (http://ecsusa.com) P6VEM3 V3. When "Rebooting" is printed to the screen, I do see a flash as if a signal is sent to reboot but perhaps is not long enough in duration. Any ideas as to where to look for a cause/solution/workaround in the source code? Perhaps I can experiment a bit. The manufacturer is non-responsive to support requests through their website.... Chris > Chris Miller wrote: > >>Number: 60646 > >>Category: misc > >>Synopsis: VIA C3 system hangs on reboot > >>Confidential: no > >>Severity: serious > >>Priority: medium > >>Responsible: freebsd-bugs > >>State: open > >>Quarter: > >>Keywords: > >>Date-Required: > >>Class: sw-bug > >>Submitter-Id: current-users > >>Arrival-Date: Sat Dec 27 23:30:20 PST 2003 > >>Closed-Date: > >>Last-Modified: > >>Originator: Chris Miller > >>Release: 4.9 Release > >>Organization: > >>Environment: > > > > FreeBSD daemon.yahp.net 4.9-RELEASE-p1 FreeBSD 4.9-RELEASE-p1 #3: Sat Dec 27 22:57:22 GMT 2003 root@daemon.yahp.net:/usr/obj/usr/src/sys/YAHP i386 > > > >>Description: > > > > This problem was previously reported in kern/41343 14 months ago, it was closed without resolution :-(. The system in question uses a VIA C3 Samuel processor running at 800Mhz. Reboot results in a system hang after fully halting and printing "Rebooting" to the console, just as reported in the original PR. I have two identical machines with the same problem. This occurs with both generic and customized kernel configurations. > > > > Copyright (c) 1992-2003 The FreeBSD Project. > > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > > The Regents of the University of California. All rights reserved. > > FreeBSD 4.9-RELEASE-p1 #3: Sat Dec 27 22:57:22 GMT 2003 > > root@daemon.yahp.net:/usr/obj/usr/src/sys/YAHP > > Timecounter "i8254" frequency 1193182 Hz > > CPU: VIA C3 Samuel 2 (801.82-MHz 686-class CPU) > > Origin = "CentaurHauls" Id = 0x673 Stepping = 3 > > Features=0x803035<FPU,DE,TSC,MSR,MTRR,PGE,MMX> > > real memory = 130023424 (126976K bytes) > > avail memory = 121139200 (118300K bytes) > > Preloaded elf kernel "kernel" at 0xc0543000. > > md0: Malloc disk > > Using $PIR table, 5 entries at 0xc00f7640 > > npx0: <math processor> on motherboard > > npx0: INT 16 interface > > pcib0: <Host to PCI bridge> on motherboard > > pci0: <PCI bus> on pcib0 > > agp0: <SIS Generic host to PCI bridge> mem 0xf4000000-0xf7ffffff at device 0.0 on pci0 > > atapci0: <SiS 5591 ATA66 controller> port 0xffa0-0xffaf,0x374-0x377,0x170-0x173,0x3f4-0x3f7,0x1f0-0x1f3 irq 0 at device 0.1 on pci0 > > ata0: at 0x1f0 irq 14 on atapci0 > > ata1: at 0x170 irq 15 on atapci0 > > isab0: <SiS 85c503 PCI-ISA bridge> at device 1.0 on pci0 > > isa0: <ISA bus> on isab0 > > sis0: <SiS 900 10/100BaseTX> port 0xdc00-0xdcff mem 0xf3ffc000-0xf3ffcfff irq 12 at device 1.1 on pci0 > > sis0: Ethernet address: 00:0a:e6:ae:17:67 > > miibus0: <MII bus> on sis0 > > ukphy0: <Generic IEEE 802.3u media interface> on miibus0 > > ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > > ohci0: <SiS 5571 USB controller> mem 0xf3ffd000-0xf3ffdfff irq 11 at device 1.2 on pci0 > > usb0: OHCI version 1.0, legacy support > > usb0: <SiS 5571 USB controller> on ohci0 > > usb0: USB revision 1.0 > > uhub0: SiS OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > > uhub0: 3 ports with 3 removable, self powered > > ohci1: <SiS 5571 USB controller> mem 0xf3ffe000-0xf3ffefff irq 11 at device 1.3 on pci0 > > usb1: OHCI version 1.0, legacy support > > usb1: <SiS 5571 USB controller> on ohci1 > > usb1: USB revision 1.0 > > uhub1: SiS OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > > uhub1: 2 ports with 2 removable, self powered > > pci0: <unknown card> (vendor=0x1039, dev=0x7018) at 1.4 irq 10 > > pcib2: <PCI to PCI bridge (vendor=1039 device=0001)> at device 2.0 on pci0 > > pci1: <PCI bus> on pcib2 > > pci1: <SiS model 6300 VGA-compatible display device> at 0.0 > > pcib1: <SiS 5591 host to AGP bridge> on motherboard > > pci2: <PCI bus> on pcib1 > > orm0: <Option ROMs> at iomem 0xc0000-0xcbfff,0xcc000-0xd3fff on isa0 > > pmtimer0 on isa0 > > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > > fdc0: FIFO enabled, 8 bytes threshold > > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > > atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 > > kbd0 at atkbd0 > > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > > sc0: <System console> at flags 0x100 on isa0 > > sc0: VGA <16 virtual consoles, flags=0x300> > > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > > sio0: type 16550A > > sio1: configured irq 3 not in bitmap of probed irqs 0 > > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 > > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode > > ppc0: FIFO with 16/16/16 bytes threshold > > ppi0: <Parallel I/O> on ppbus0 > > plip0: <PLIP network interface> on ppbus0 > > lpt0: <Printer> on ppbus0 > > lpt0: Interrupt-driven port > > ipfw2 initialized, divert disabled, rule-based forwarding enabled, default to accept, logging unlimited > > ad0: 29325MB <Maxtor 6E030L0> [59582/16/63] at ata0-master UDMA66 > > acd0: CDROM <ATAPI-CD ROM-DRIVE-52MAX> at ata1-slave PIO4 > > Mounting root from ufs:/dev/ad0s1a > > > > > > > >>How-To-Repeat: > > > > Type reboot :-) > > > >>Fix: > > > > > > > >>Release-Note: > >>Audit-Trail: > >>Unformatted: > > > > _______________________________________________ > > freebsd-bugs@freebsd.org mailing list > > http://lists.freebsd.org/mailman/listinfo/freebsd-bugs > > To unsubscribe, send any mail to "freebsd-bugs-unsubscribe@freebsd.org" > > > > > >
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200401020610.i026AFR8032311>