Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 22 Jan 2010 11:49:26 -0800
From:      Jack Vogel <jfvogel@gmail.com>
To:        Mike Tancsa <mike@sentex.net>
Cc:        freebsd-current@freebsd.org
Subject:   Re: em0 on H55 chipset problems
Message-ID:  <2a41acea1001221149t6afffd26vaa98a5a3ad6a350f@mail.gmail.com>
In-Reply-To: <201001221340.o0MDeXKF011833@lava.sentex.ca>
References:  <201001221340.o0MDeXKF011833@lava.sentex.ca>

next in thread | previous in thread | raw e-mail | index | archive | help
Mike, can you tell me more details about the system, is this a laptop?

Jack


On Fri, Jan 22, 2010 at 5:40 AM, Mike Tancsa <mike@sentex.net> wrote:

> Not sure how easy it is to repeat, but running HEAD from yesterday causes
> the em0 do post a
> em0: Watchdog timeout -- resetting
> to the serial console on a new i3 system that we just got to test with. At
> that point, the box's network is no longer responding. It netboots off em0
> so not sure if the hang after that is nfs not recovering or not, but it does
> not respond to network traffic at all.
>
> em0@pci0:0:25:0:        class=0x020000 card=0x00368086 chip=0x10f08086
> rev=0x06 hdr=0x00
>    vendor     = 'Intel Corporation'
>    class      = network
>    subclass   = ethernet
>    cap 01[c8] = powerspec 2  supports D0 D3  current D0
>    cap 05[d0] = MSI supports 1 message, 64 bit enabled with 1 message
>    cap 13[e0] = PCI Advanced Features: FLR TP
> ehci0@pci0:0:26:0:      class=0x0c0320 card=0x00368086 chip=0x3b3c8086
> rev=0x06 hdr=0x00
>
> Copyright (c) 1992-2010 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>        The Regents of the University of California. All rights reserved.
> FreeBSD is a registered trademark of The FreeBSD Foundation.
> FreeBSD 9.0-CURRENT #0: Thu Jan 21 15:14:14 EST 2010
>    mdtancsa@ich10.sentex.ca:/usr/HEAD/obj/usr/HEAD/src/sys/alix i386
> Timecounter "i8254" frequency 1193182 Hz quality 0
> CPU: Intel(R) Core(TM) i3 CPU         530  @ 2.93GHz (2926.02-MHz 686-class
> CPU)
>  Origin = "GenuineIntel"  Id = 0x20652  Stepping = 2
>
>  Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
>
>  Features2=0x98e3bd<SSE3,DTES64,MON,DS_CPL,VMX,EST,TM2,SSSE3,CX16,xTPR,PDCM,SSE4.1,SSE4.2,POPCNT>
>  AMD Features=0x28100000<NX,RDTSCP,LM>
>  AMD Features2=0x1<LAHF>
>  TSC: P-state invariant
> real memory  = 1073741824 (1024 MB)
> avail memory = 894119936 (852 MB)
> ACPI APIC Table: <INTEL  DH55TC  >
> FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
> FreeBSD/SMP: 1 package(s) x 2 core(s)
>  cpu0 (BSP): APIC ID:  0
>  cpu1 (AP): APIC ID:  4
> ACPI Warning: 32/64X FACS address mismatch in FADT - 3762AE40/
> 03762AD40, using 32 (20091214/tbfadt-586)
> ioapic0 <Version 2.0> irqs 0-23 on motherboard
> kbd1 at kbdmux0
> cryptosoft0: <software crypto> on motherboard
> acpi0: <INTEL DH55TC> on motherboard
> acpi0: [ITHREAD]
> acpi0: Power Button (fixed)
> Timecounter "ACPI-safe" frequency 3579545 Hz quality 850
> acpi_timer0: <24-bit timer at 3.579545MHz> port 0x408-0x40b on acpi0
> acpi_hpet0: <High Precision Event Timer> iomem 0xfed00000-0xfed003ff on
> acpi0
> Timecounter "HPET" frequency 14318180 Hz quality 900
> pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
> pci0: <ACPI PCI bus> on pcib0
> vgapci0: <VGA-compatible display> port 0xf100-0xf107 mem
> 0xfe000000-0xfe3fffff,0xd0000000-0xdfffffff irq 16 at device 2.0 on pci0
> pci0: <simple comms> at device 22.0 (no driver attached)
> atapci0: <Intel ATA controller> port
> 0xf0f0-0xf0f7,0xf0e0-0xf0e3,0xf0d0-0xf0d7,0xf0c0-0xf0c3,0xf0b0-0xf0bf irq 18
> at device 22.2 on pci0
> atapci0: [ITHREAD]
> ata2: <ATA channel 0> on atapci0
> ata2: [ITHREAD]
> ata3: <ATA channel 1> on atapci0
> ata3: [ITHREAD]
> pci0: <simple comms, UART> at device 22.3 (no driver attached)
> em0: <Intel(R) PRO/1000 Network Connection 6.9.24> port 0xf040-0xf05f mem
> 0xfe400000-0xfe41ffff,0xfe428000-0xfe428fff irq 20 at device 25.0 on pci0
> em0: Using MSI interrupt
> em0: [FILTER]
> em0: Ethernet address: 00:27:0e:09:5e:00
> ehci0: <Intel PCH USB 2.0 controller USB-B> mem 0xfe427000-0xfe4273ff irq
> 16 at device 26.0 on pci0
> ehci0: [ITHREAD]
> usbus0: EHCI version 1.0
> usbus0: <Intel PCH USB 2.0 controller USB-B> on ehci0
> pci0: <multimedia, HDA> at device 27.0 (no driver attached)
> pcib1: <ACPI PCI-PCI bridge> irq 17 at device 28.0 on pci0
> pci1: <ACPI PCI bus> on pcib1
> pcib2: <ACPI PCI-PCI bridge> irq 17 at device 28.4 on pci0
> pci2: <ACPI PCI bus> on pcib2
> ehci1: <Intel PCH USB 2.0 controller USB-A> mem 0xfe426000-0xfe4263ff irq
> 23 at device 29.0 on pci0
> ehci1: [ITHREAD]
> usbus1: EHCI version 1.0
> usbus1: <Intel PCH USB 2.0 controller USB-A> on ehci1
> pcib3: <ACPI PCI-PCI bridge> at device 30.0 on pci0
> pci3: <ACPI PCI bus> on pcib3
> isab0: <PCI-ISA bridge> at device 31.0 on pci0
> isa0: <ISA bus> on isab0
> atapci1: <Intel AHCI controller> port
> 0xf090-0xf097,0xf080-0xf083,0xf070-0xf077,0xf060-0xf063,0xf020-0xf03f mem
> 0xfe425000-0xfe4257ff irq 19 at device 31.2 on pci0
> atapci1: [ITHREAD]
> atapci1: AHCI v1.30 controller with 6 3Gbps ports, PM not supported
> ata4: <ATA channel 0> on atapci1
> ata4: [ITHREAD]
> ata5: <ATA channel 1> on atapci1
> ata5: [ITHREAD]
> ata6: <ATA channel 2> on atapci1
> ata6: [ITHREAD]
> ata7: <ATA channel 3> on atapci1
> ata7: [ITHREAD]
> ata8: <ATA channel 4> on atapci1
> ata8: [ITHREAD]
> ata9: <ATA channel 5> on atapci1
> ata9: [ITHREAD]
> pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
> acpi_button0: <Power Button> on acpi0
> atrtc0: <AT realtime clock> port 0x70-0x71 irq 8 on acpi0
> atkbdc0: <Keyboard controller (i8042)> port 0x60,0x64 irq 1 on acpi0
> atkbd0: <AT Keyboard> irq 1 on atkbdc0
> kbd0 at atkbd0
> atkbd0: [GIANT-LOCKED]
> atkbd0: [ITHREAD]
> uart0: <16550 or compatible> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
> uart0: [FILTER]
> uart0: console (9600,n,8,1)
> cpu0: <ACPI CPU> on acpi0
> est0: <Enhanced SpeedStep Frequency Control> on cpu0
> p4tcc0: <CPU Frequency Thermal Control> on cpu0
> cpu1: <ACPI CPU> on acpi0
> est1: <Enhanced SpeedStep Frequency Control> on cpu1
> p4tcc1: <CPU Frequency Thermal Control> on cpu1
> pmtimer0 on isa0
> orm0: <ISA Option ROM> at iomem 0xcd000-0xcdfff pnpid ORM0000 on isa0
> sc0: <System console> at flags 0x100 on isa0
> sc0: VGA <16 virtual consoles, flags=0x300>
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
> ata0: [ITHREAD]
> ata1 at port 0x170-0x177,0x376 irq 15 on isa0
> ata1: [ITHREAD]
> Timecounters tick every 1.000 msec
> IPsec: Initialized Security Association Processing.
> usbus0: 480Mbps High Speed USB v2.0
> usbus1: 480Mbps High Speed USB v2.0
> ad0: 76319MB <Seagate ST380811AS 3.AAE> at ata4-master UDMA100 SATA 1.5Gb/s
> SMP: AP CPU #1 Launched!
> ugen0.1: <Intel> at usbus0ugen1.1: <Intel> at usbus1
> uhub0:
> <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
> uhub1: <Intel EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus1
> Root mount waiting for: usbus1 usbus0
> Root mount waiting for: usbus1 usbus0
> uhub0: 3 ports with 3 removable, self powered
> uhub1: 3 ports with 3 removable, self powered
> Root mount waiting for: usbus1 usbus0
> ugen0.2: <vendor 0x8087> at usbus0
> uhub2: <vendor 0x8087 product 0x0020, class 9/0, rev 2.00/0.00, addr 2> on
> usbus0
> ugen1.2: <vendor 0x8087> at usbus1
> uhub3: <vendor 0x8087 product 0x0020, class 9/0, rev 2.00/0.00, addr 2> on
> usbus1
> uhub2: 6 ports with 6 removable, self powered
> Root mount waiting for: usbus1
> uhub3: 6 ports with 6 removable, self powered
> Trying to mount root from nfs:
> NFS ROOT: 10.255.255.1:/usr/home/pxe9/
>
> --------------------------------------------------------------------
> Mike Tancsa,                                      tel +1 519 651 3400
> Sentex Communications,                            mike@sentex.net
> Providing Internet since 1994                    www.sentex.net
> Cambridge, Ontario Canada                         www.sentex.net/mike
>
>



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?2a41acea1001221149t6afffd26vaa98a5a3ad6a350f>