Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 15 Jun 2005 06:40:03 -0400
From:      "Anthony M. Agelastos" <iqgrande@gmail.com>
To:        asa@ma3x.net
Cc:        freebsd-questions@freebsd.org
Subject:   Re: Very slow printing on 5.4 with cups anh HP LaserJet 4L
Message-ID:  <42B00583.6080207@gmail.com>
In-Reply-To: <60054.212.116.143.100.1118829379.squirrel@mail.ma3x.net>
References:  <60054.212.116.143.100.1118829379.squirrel@mail.ma3x.net>

next in thread | previous in thread | raw e-mail | index | archive | help
asa@ma3x.net wrote:

>I have a problem with very slow printing after replacing 4.1 instalation
>with new 5.4 instalation (clean install, not upgrade). The printer is HP
>4L, and i use it with up to date CUPS (all packages + gimp-print). With
>both CUPS ang gimp-print drivers and default port settings the dokument
>printing speed is about 8k each 1 minute (acording to CUPS web interface).
>There are no error messages from the kernel. With hint.ppc.0.falgs="0x20"
>or "0x80" there is the same effect.
>
>With hint.ppc.0.falgs="0x20", "0x40", "0x48" and "0x88" CUPS web interface
>shows taht first 32k are sent instantly. Then 'Interrupt storm detected on
>"irq5: lpt0"; throttling interrupt source' kernel error message apears and
>the rest of the document prints slow, as in the first example.
>
>I tried this with several standard and HP bidirectional cables. I also
>tried all possible BIOS settings for the port.
>
>The old 4.1 instalation prints without problems.
>
>
>_______________________________________________
>freebsd-questions@freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-questions
>To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
>
>  
>
Hello. I am new to FreeBSD, so if anyone else has better advice on this 
matter, please chime in. The only things I can think of are:

1. hint.ppc.0.falgs= is what you typed above twice. Make sure that this 
is not misspelled in the device.hints file (it should be flags... not 
falgs).
2. Try 0x28.
3. Read a thread from the archives in April 2005 entitled "Very slow 
printing with stock FreeBSD5.3 + CUPS + Gimp-Print + HPDeskJet612C" ( 
http://lists.freebsd.org/mailman/htdig/freebsd-questions/2005-April/thread.html#84258 
). In there, they mention having to possibly remove a line and possibly 
adding another one. They also mention some other drivers that might work 
better for you.
4. Try going through lptcontrol. Chapter 9 of the FreeBSD Handbook goes 
over this a bit. 
http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/printing-intro-setup.html

I hope this helps. And, if anyone else has any ideas, please add 'em. 
Good luck.

-Anthony



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?42B00583.6080207>