Date: Fri, 14 Jul 2006 21:02:17 +0200 From: Miroslav Lachman <000.fbsd@quip.cz> To: freebsd-stable@freebsd.org Subject: Re: ATA problems again ... Message-ID: <44B7EA39.4060509@quip.cz> In-Reply-To: <20060713132357.Y61840@fledge.watson.org> References: <DAFCD4DC-D2D4-4574-ACBF-367D642D9729@stromnet.org> <8D08DDB6-6AC1-45B6-B2CE-08782F54968A@stromnet.org> <884C01BC-3E97-46EC-AA8B-E70C3931F3A4@stromnet.org> <36895211-2796-4213-B336-6279AB3AC3CB@stromnet.org> <20060713132357.Y61840@fledge.watson.org>
next in thread | previous in thread | raw e-mail | index | archive | help
Robert Watson wrote:
> I don't have a whole lot to add to this thread, but have changed the
> subject to make sure that the right people are reading this. This is
> likely either a hardware problem (motherboard/cable/drive) or driver
> problem. GEOM and the mirror driver seems to be behaving as desired (it
> detaches a drive reported by the driver as being bad). Could you post
> the dmesg -v output for the probing of the ata controller and driver?
Same problem here first (ad4) or second (ad8) disk disappear from the
system about once a day. Independent of disk / CPU load. Sometimes
without any load, today when I was stress testing the disks with copying
/usr/ports to another slice in cycle - after 3 hours I got:
Jul 14 19:05:45 track kernel: ad8: FAILURE - device detached
Jul 14 19:05:45 track kernel: subdisk8: detached
Jul 14 19:05:45 track kernel: ad8: detached
Jul 14 19:05:45 track kernel: GEOM_MIRROR: Device gm0: provider ad8
disconnected.
Jul 14 19:05:45 track kernel:
g_vfs_done():mirror/gm0s1h[READ(offset=6345932800, length=65536)]error = 6
Jul 14 19:05:45 track kernel: vnode_pager_getpages: I/O read error
Jul 14 19:05:45 track kernel: vm_fault: pager read error, pid 5108 (cp)
After reboot (command reboot), system boot up with both disks attached
and start autosynchronization. I do not know, if this is hw or sw error,
I got two same machines with almost equal SW setup and realy equal HW
setup, but this errors ocurres on one of them only.
dmesg.boot before ad8 failure (rebuilding ad4 from previous failure):
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 6.1-RELEASE #0: Sun May 7 04:42:56 UTC 2006
root@opus.cse.buffalo.edu:/usr/obj/usr/src/sys/SMP
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) 4 CPU 3.00GHz (3000.12-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0xf43 Stepping = 3
Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
Features2=0x649d<SSE3,RSVD2,MON,DS_CPL,EST,CNTX-ID,CX16,<b14>>
AMD Features=0x20100000<NX,LM>
Logical CPUs per core: 2
real memory = 1073610752 (1023 MB)
avail memory = 1041489920 (993 MB)
ACPI APIC Table: <A M I OEMAPIC >
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
cpu0 (BSP): APIC ID: 0
cpu1 (AP): APIC ID: 1
ioapic0: Changing APIC ID to 2
ioapic1: Changing APIC ID to 3
ioapic0 <Version 2.0> irqs 0-23 on motherboard
ioapic1 <Version 2.0> irqs 24-47 on motherboard
kbd1 at kbdmux0
acpi0: <A M I OEMRSDT> on motherboard
acpi_bus_number: can't get _ADR
acpi_bus_number: can't get _ADR
acpi_bus_number: can't get _ADR
acpi_bus_number: can't get _ADR
acpi0: Power Button (fixed)
acpi_bus_number: can't get _ADR
acpi_bus_number: can't get _ADR
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x808-0x80b on acpi0
cpu0: <ACPI CPU> on acpi0
acpi_throttle0: <ACPI CPU Throttling> on cpu0
cpu1: <ACPI CPU> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pcib1: <ACPI PCI-PCI bridge> irq 16 at device 28.0 on pci0
pci1: <ACPI PCI bus> on pcib1
pcib2: <ACPI PCI-PCI bridge> at device 0.0 on pci1
pci2: <ACPI PCI bus> on pcib2
pcib3: <ACPI PCI-PCI bridge> irq 16 at device 28.4 on pci0
pci3: <ACPI PCI bus> on pcib3
bge0: <Broadcom BCM5721 Gigabit Ethernet, ASIC rev. 0x4101> mem
0xfc8f0000-0xfc8fffff irq 16 at device 0.0 on pci3
miibus0: <MII bus> on bge0
brgphy0: <BCM5750 10/100/1000baseTX PHY> on miibus0
brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX,
1000baseTX-FDX, auto
bge0: Ethernet address: 00:15:f2:ec:43:69
pcib4: <ACPI PCI-PCI bridge> irq 17 at device 28.5 on pci0
pci4: <ACPI PCI bus> on pcib4
bge1: <Broadcom BCM5721 Gigabit Ethernet, ASIC rev. 0x4101> mem
0xfc9f0000-0xfc9fffff irq 17 at device 0.0 on pci4
miibus1: <MII bus> on bge1
brgphy1: <BCM5750 10/100/1000baseTX PHY> on miibus1
brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX,
1000baseTX-FDX, auto
bge1: Ethernet address: 00:15:f2:ec:43:6a
uhci0: <UHCI (generic) USB controller> port 0xec00-0xec1f irq 23 at
device 29.0 on pci0
uhci0: [GIANT-LOCKED]
usb0: <UHCI (generic) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <UHCI (generic) USB controller> port 0xe880-0xe89f irq 19 at
device 29.1 on pci0
uhci1: [GIANT-LOCKED]
usb1: <UHCI (generic) USB controller> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
ehci0: <Intel 82801GB/R (ICH7) USB 2.0 controller> mem
0xfebffc00-0xfebfffff irq 23 at device 29.7 on pci0
ehci0: [GIANT-LOCKED]
usb2: EHCI version 1.0
usb2: companion controllers, 2 ports each: usb0 usb1
usb2: <Intel 82801GB/R (ICH7) USB 2.0 controller> on ehci0
usb2: USB revision 2.0
uhub2: Intel EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub2: 4 ports with 4 removable, self powered
pcib5: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci5: <ACPI PCI bus> on pcib5
pci5: <display, VGA> at device 2.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH7 UDMA100 controller> port
0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xffa0-0xffaf at device 31.1 on pci0
ata0: <ATA channel 0> on atapci0
ata1: <ATA channel 1> on atapci0
atapci1: <Intel ICH7 SATA300 controller> port
0xe800-0xe807,0xe480-0xe483,0xe400-0xe407,0xe080-0xe083,0xe000-0xe00f
mem 0xfebff800-0xfebffbff irq 19 at device 31.2 on pci0
ata2: <ATA channel 0> on atapci1
ata3: <ATA channel 1> on atapci1
ata4: <ATA channel 2> on atapci1
ata5: <ATA channel 3> on atapci1
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
acpi_button0: <Power Button> on acpi0
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 flags 0x10 on
acpi0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
sio1: <16550A-compatible COM port> port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
fdc0: <floppy drive controller (FDE)> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2
on acpi0
fdc0: [FAST]
ppc0: <Standard parallel printer port> port 0x378-0x37f irq 7 on acpi0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
atkbdc0: <Keyboard controller (i8042)> port 0x60,0x64 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xc0000-0xc7fff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 1.000 msec
acd0: DVDROM <ASUS DVD-E616A2/1.02> at ata0-slave UDMA100
ad4: 238475MB <Seagate ST3250820AS 3.AAC> at ata2-master SATA150
GEOM_MIRROR: Device gm0 created (id=565164480).
GEOM_MIRROR: Device gm0: provider ad4 detected.
ad8: 238475MB <Seagate ST3250820AS 3.AAC> at ata4-master SATA150
SMP: AP CPU #1 Launched!
GEOM_MIRROR: Device gm0: provider ad8 detected.
GEOM_MIRROR: Device gm0: provider ad8 activated.
GEOM_MIRROR: Device gm0: provider mirror/gm0 launched.
GEOM_MIRROR: Device gm0: rebuilding provider ad4.
Trying to mount root from ufs:/dev/mirror/gm0s1a
bge0: link state changed to UP
uname:
FreeBSD 6.1-RELEASE #0: Sun May 7 04:42:56 UTC 2006
root@opus.cse.buffalo.edu:/usr/obj/usr/src/sys/SMP i386
Miroslav Lachman
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?44B7EA39.4060509>