Date: Wed, 26 Apr 1995 00:01:14 -0400 From: kelly@fsl.noaa.gov (Sean Kelly) To: tom@haven.uniserve.com Cc: rgrimes@gndrsh.aac.dev.com, hackers@FreeBSD.org Subject: Re: Buslogic? Message-ID: <9504260401.AA12862@yarmouth.fsl.noaa.gov> In-Reply-To: <Pine.BSF.3.91.950425205014.18088C-100000@haven.uniserve.com> (message from Tom Samplonius on Tue, 25 Apr 1995 20:54:52 -0700 (PDT))
next in thread | previous in thread | raw e-mail | index | archive | help
>>>>> "Tom" == Tom Samplonius <tom@haven.uniserve.com> writes:
Tom> I E800 mentioned at the bottom of the main AutoSCSI screen
Tom> near the bottom. I also see it when I choose "Select
Tom> Adapter". My card may be newer.... I also have option on
Tom> *not* using a ISA IO port at all!
Must be! I have firmware rev 4.22 and BIOS rev 4.86. You?
Tom> I need to leave the jumpers off, or it won't boot. My
Tom> motherboard insists on autoconfiging the card :) (nice to
Tom> have PCI that works!).
Finally!
>> I tried booting with -c and setting the I/O port to e800, but
>> the kernel always reports `bt0 not found at e800'. At least I
>> get sync mode.
Tom> All this did for me, was detect it as EISA device!
Tom> Performance showed no changed. I wouldn't worry about it
Tom> unless your 946C is a slow as mine!
In the 2.0-RELEASE isa.c, line 454 or so, the following shows up:
if (isdp->id_iobase >= 0x1000) {
printf (" on eisa\n");
} else {
printf (" on isa\n");
}
So, I'll try to stop worrying about it ... next step: going to fast
sync mode. Good luck.
--
Sean Kelly
NOAA Forecast Systems Lab, Boulder Colorado USA
When you're going up the stairs and you take a step, kick the other
leg up high behind you to keep people from following too close.
-- Jack Handey
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?9504260401.AA12862>