Date: Fri, 04 Aug 2017 06:15:52 +0000 From: Yoshiro MIHIRA <sanpei.ml@gmail.com> To: freebsd-arm <freebsd-arm@freebsd.org> Subject: boot.ini file for Odroid-C1 on FreeBSD wiki page Message-ID: <CALwmBx0zjVpUNK3oYjkzEVxxLkz3FqTOprS4quXvTv-Eu7fBVg@mail.gmail.com>
next in thread | raw e-mail | index | archive | help
Hi all. Currently I setuped DROID-C1 with FreeBSD-12-current with below steps https://wiki.freebsd.org/FreeBSD/arm/Odroid-C1 <-- (1) But I got below message in boot sequence, u-boot could not find boot.ini. I think there is no step to create boot.ini in FreeBSD wiki page(1). I need to put boot.ini on MS-DOS partition. I will add boot.ini information to FreeBSD wiki page(1), if no one reply my email until 10/Aug. MMC read: dev # 0, block # 33984, count 12288 ... 12288 blocks read: OK There is no valid bmp file at the given address ============================================================ Vendor: Man 744a60 Snr 4116ca3f Rev: 2.0 Prod: USDU1 Type: Removable Hard Disk Capacity: 15343.0 MB = 14.9 GB (31422464 x 512) ------------------------------------------------------------ Partition Start Sector Num Sectors Type 1 1134 131040 6 2 132174 31290273 a5 ============================================================ Net: Meson_Ethernet init suspend firmware done. (ret:0) Hit Enter key to stop autoboot -- : 0 exit abortboot: 0 reading boot.ini ** Unable to read "boot.ini" from mmc 0:1 ** Loading file "/boot/boot.ini" from mmc device 0:1 xxa1 Failed to mount ext2 filesystem... ** Bad ext2 partition or disk - mmc 0:1 ** Loading file "/boot/boot.ini" from mmc device 0:2 xxa2 Failed to mount ext2 filesystem... ** Bad ext2 partition or disk - mmc 0:2 ** Failed to load boot.init, maybe empty file? MMC read: dev # 0, block # 1216, count 16384 ... 16384 blocks read: OK MMC read: dev # 0, block # 1088, count 128 ... 128 blocks read: OK Wrong Image Format for bootm command my boot.ini. ODROIDC-UBOOT-CONFIG setenv bootcmd "fatload mmc 0 0x100000 kernel.bin; go 0x100000" run bootcmd ---- Thanks Yosihro MIHIRA Tokyo, Japan
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?CALwmBx0zjVpUNK3oYjkzEVxxLkz3FqTOprS4quXvTv-Eu7fBVg>