Date: Fri, 14 May 1999 10:50:27 +0200 (CEST) From: Peter Hakanson <peter@netman.se> To: freebsd-multimedia@freebsd.org Subject: Machine hangs when using h261 encoding Message-ID: <Pine.BSF.3.96.990514104645.4046G-100000@warp.hq.gbg.netman.se>
next in thread | raw e-mail | index | archive | help
When trying the "mbone-tools" i discovered an
anomaly :
=20
using vic might get the system to hang. Hard, does
not answer to ping, no reaction to any keys, mouse dead.
=20
No logging in syslog. Just simply dies(hard). Manual
reboot needed.
=20
It seems to be triggered by switching between video modes,
switchning into or out of h.261 (or enabling transmit when
using h261 mode).
=20
The system is 2.2.7, i have read through the brooktree driver for
3.1 but cannot find fixes for this kind of problem.
Ethernet card is inter pro 10/100 in 10mbit speed.
=20
Camera is Pxelview meetimg pac PAL version.
board is a TYN TITAN VX V3.0
Booting -v shows up this info
Copyright (c) 1992-1998 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
=09The Regents of the University of California. All rights reserved.
FreeBSD 2.2.7-RELEASE #0: Tue May 11 18:12:14 CEST 1999
root@benet.gbg.netman.se:/usr/src/sys/compile/MBONE-PCM
Calibrating clock(s) ... i586 clock: 199425948 Hz, i8254 clock: 1193148 Hz
CLK_USE_I8254_CALIBRATION not specified - using default frequency
CLK_USE_I586_CALIBRATION not specified - using old calibration method
CPU: Pentium/P55C (199.43-MHz 586-class CPU)
Origin =3D "GenuineIntel" Id =3D 0x544 Stepping=3D4
Features=3D0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory =3D 67108864 (65536K bytes)
Physical memory chunk(s):
0x00001000 - 0x0009efff, 647168 bytes (158 pages)
0x00251000 - 0x03ffdfff, 64671744 bytes (15789 pages)
avail memory =3D 63168512 (61688K bytes)
DPT: RAID Manager driver, Version 1.0.5
pcibus_setup(1):=09mode 1 addr port (0x0cf8) is 0x80000058
pcibus_setup(1a):=09mode1res=3D0x80000000 (0x80000000)
pcibus_check:=09device 0 is there (id=3D70308086)
Probing for devices on PCI bus 0:
=09configuration mode 1 allows 32 devices.
chip0 <Intel 82437VX PCI cache memory controller> rev 2 on pci0:0:0
=09PCI Concurrency: enabled
=09Cache: 256K pipelined-burst secondary; L1 enabled
=09DRAM: no memory hole, 66 MHz refresh
=09Read burst timing: x-2-2-2/x-3-3-3
=09Write burst timing: x-2-2-2
=09RAS-CAS delay: 3 clocks
chip1 <Intel 82371SB PCI-ISA bridge> rev 1 on pci0:7:0
=09I/O Recovery Timing: 8-bit 1 clocks, 16-bit 1 clocks
=09Extended BIOS: disabled
=09Lower BIOS: disabled
=09Coprocessor IRQ13: enabled
=09Mouse IRQ12: enabled
=09Interrupt Routing: A: IRQ11, B: IRQ10, C: disabled, D: IRQ9
=09=09MB0: IRQ15, MB1:=20
chip2 <Intel 82371SB IDE interface> rev 0 on pci0:7:1
=09mapreg[20] type=3D1 addr=3D0000f000 size=3D0010.
=09Primary IDE: enabled
=09Secondary IDE: enabled
vga0 <VGA-compatible display device> rev 1 int a irq 9 on pci0:12:0
=09mapreg[10] type=3D0 addr=3De0900000 size=3D4000.
=09mapreg[14] type=3D0 addr=3De0000000 size=3D800000.
fxp0 <Intel EtherExpress Pro 10/100B Ethernet> rev 2 int a irq 10 on pci0:1=
4:0
=09mapreg[10] type=3D0 addr=3De0904000 size=3D1000.
=09mapreg[14] type=3D1 addr=3D00006100 size=3D0020.
=09mapreg[18] type=3D0 addr=3De0800000 size=3D100000.
=09reg16: virtual=3D0xf5690000 physical=3D0xe0904000 size=3D0x1000
fxp0: Ethernet address 00:a0:c9:42:41:d8
bpf: fxp0 attached
bktr0 <BrookTree 848> rev 18 int a irq 11 on pci0:15:0
=09mapreg[10] type=3D0 addr=3De0905000 size=3D1000.
=09reg16: virtual=3D0xf5691000 physical=3D0xe0905000 size=3D0x1000
brooktree0: PCI bus latency is 32.
bktr0: buffer size 3555328, addr 0x3000000
bktr: GPIO is 0x00ffffff
Hauppauge WinCast/TV, Temic NTSC tuner, dbx stereo, msp3400c stereo.
pci0: uses 9461760 bytes of memory from e0000000 upto e0905fff.
pci0: uses 48 bytes of I/O space from 6100 upto f00f.
Probing for PnP devices:
Trying Read_Port at 203
Trying Read_Port at 243
CSN 1 Vendor ID: CTLfff1 [0xf1ff8c0e] Serial 0x1005a1d6
Probing for devices on the ISA bus:
sc0: the current keyboard controller command byte 0047
kbdio: DIAGNOSE status:0055
kbdio: TEST_KBD_PORT status:0000
kbdio: RESET_KBD return code:00fa
kbdio: RESET_KBD status:00aa
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: BIOS video mode:3
sc0: VGA registers upon power-up
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81=20
bf 1f 00 4f 0e 0f 00 00 07 80 9c 8e 8f 28 1f 96=20
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c=20
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff=20
sc0: video mode:24
sc0: VGA registers in BIOS for mode:24
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81=20
bf 1f 00 4f 0d 0e 00 00 00 00 9c 8e 8f 28 1f 96=20
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c=20
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff=20
sc0: VGA registers to be used for mode:24
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81=20
bf 1f 00 4f 0d 0e 00 00 00 00 9c 8e 8f 28 1f 96=20
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c=20
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff=20
sc0: rows_offset:1
sc0: VGA color <16 virtual consoles, flags=3D0x0>
sio0: irq maps: 0x1 0x11 0x1 0x1
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16550A
sio1: irq maps: 0x1 0x9 0x1 0x1
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
sio2: disabled, not probed.
sio3: disabled, not probed.
lpt0 at 0x378-0x37f irq 7 on isa
lpt0: Interrupt-driven port
lp0: TCP/IP capable interface
bpf: lp0 attached
lpt1 not found at 0xffffffff
psm0: current command byte:0047
kbdio: TEST_AUX_PORT status:0000
kbdio: RESET_AUX return code:00fa
kbdio: RESET_AUX status:00aa
kbdio: RESET_AUX ID:0000
psm: status 00 02 64
psm: status 00 00 64
psm: status 00 03 64
psm: status 00 03 64
psm: status 10 00 64
psm: data 08 00 00
psm: data 08 00 00
psm: status 00 02 64
psm0 at 0x60-0x64 irq 12 on motherboard
psm0: model Generic PS/2 mouse, device ID 0, 2 buttons
psm0: config:00000000, flags:00000000, packet size:3
psm0: syncmask:c0, syncbits:00
mss_detect error, busy still set (0xff)
pcm0 at 0x220 irq 5 drq 1 flags 0x15 on isa
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <FUJITSU MPC3032AT>
wd0: 3093MB (6335280 sectors), 6704 cyls, 15 heads, 63 S/T, 512 B/S
wdc1 at 0x170-0x177 irq 15 on isa
wdc1: unit 0 (atapi): <NEC CD-ROM DRIVE:282/4.62>, removabl=
e, dma, iordy
wcd0: 2412/5512Kb/sec, 128Kb cache, audio play, 256 volume levels, ejectabl=
e tray
wcd0: medium type unknown, unlocked
npx0 flags 0x1 on motherboard
npx0: INT 16 interface
apm0: disabled, not probed.
imasks: bio c008c040, tty c0071cba, net c0071cba
BIOS Geometries:
0:030f7f3f 0..783=3D784 cylinders, 0..127=3D128 heads, 1..63=3D63 sectors
0 accounted for
Device configuration finished.
Intel Pentium F00F detected, installing workaround
bpf: tun0 attached
bpf: sl0 attached
bpf: ppp0 attached
new masks: bio c008c040, tty c0071cba, net c0071cba
bpf: lo0 attached
Considering FFS root f/s.
wd0s1: type 0xa5, start 63, end =3D 1636991, size 1636929 : OK
wd0s2: type 0x6, start 1636992, end =3D 5830271, size 4193280 : OK
Any clues of whats happening ?
--
Peter H=E5kanson Phone +46 0708 39 23 04
Network Management AB Fax +46 031 779 7844
pub 1024/3D18CE6D 1998/04/03 Peter Hakanson<peter@netman.se>
Key fingerprint =3D F2 BC E6 DF 8F D5 A2 1D 12 52 4C 1E 12 87 81 20
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-multimedia" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.3.96.990514104645.4046G-100000>