Date: Sat, 7 Nov 1998 12:15:36 -0800 (PST) From: Matthew Jacob <mjacob@feral.com> To: freebsd-alpha@FreeBSD.ORG Subject: alphaPC164 boot messages Message-ID: <Pine.LNX.4.02.9811071206020.7469-100000@feral-gw>
next in thread | raw e-mail | index | archive | help
Just in case someone more on top of the current state sees something in all of this, here's where I get to on the AlphaPC164... The prom input device is working at a pont because it passed along the Enter I hit below... >>>b dka200 -fl h (boot dka200.2.0.5.0 -flags h) block 0 of dka200.2.0.5.0 is a valid boot block reading 14 blocks from dka200.2.0.5.0 bootstrap code read in base = 172000, image_start = 0, image_bytes = 1c00 initializing HWRPB at 2000 initializing page table at 164000 initializing machine state setting affinity to the primary CPU jumping to bootstrap code Console: SRM firmware console VMS PAL rev: 0x1000900010113 OSF PAL rev: 0x1000800020115 Switch to OSF PAL code succeeded. FreeBSD/alpha SRM disk boot, Revision (jkh@beast.cdrom.com, Fri Nov 6 08:42:47 GMT 1998) Memory: 262144 k can't open '/boot/boot.conf': no such file or directory Hit [Enter] to boot immediately, or any other key for command prompt. Booting [kernel]... /kernel data=0x4ac2e0+0x266c8 syms=[0x8+0x3d578+0x8+0x233f5] Entering kernel at 0xfffffc00003205a0... Copyright (c) 1992-1998 FreeBSD Inc. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. FreeBSD 3.0-19981105-SNAP #2: Fri Nov 6 16:52:40 GMT 1998 jkh@beast.cdrom.com:/usr/src/sys/compile/BOOTMFS EB164 Digital AlphaPC 164 432 MHz, 432MHz 8192 byte page size, 1 processor. real memory = 265961472 (259728K bytes) avail memory = 251371520 (245480K bytes) Preloaded elf kernel "kernel" at 0xfffffc0000836000. cia0: <2117x PCI adapter> cia0: ALCOR/ALCOR2, pass 3 cia0: extended capabilities: 21<DWEN,BWEN> isa0 Probing for devices on PCI bus 0: Qlogic ISP Driver, FreeBSD CAM Version 0.97, Core Version 1.3 isp0: <Qlogic ISP 10X0 PCI SCSI Adapter> rev 0x05 int a irq 2 on pci0.5.0 isp0: using Memory space register mapping isp0: Board Revision 1040B, loaded F/W Revision 7.55 isp0: Last F/W revision was 2.10 de0: <Digital 21140A Fast Ethernet> rev 0x20 int a irq 1 on pci0.7.0 de0: 21140A [10-100Mb/s] pass 2.0 de0: address 00:c0:f0:16:2d:7c chip0: <Intel 82378IB PCI to ISA bridge> rev 0x43 on pci0.8.0 isp1: <Qlogic ISP 2100 PCI FC-AL Adapter> rev 0x03 int a irq 3 on pci0.9.0 isp1: using Memory space register mapping isp1: Board Revision 2100, loaded F/W Revision 1.15 isp1: Adapter WWN 0x200000e08b003c1f isp1: Firmware State Config Wait -> Waiting for AL/PA isp1: Firmware State Waiting for AL/PA -> Wait Login isp1: Firmware State Wait Login -> Ready isp1: Loop ID 0x0, ALPA 0xef mcclock0: <MC146818A real time clock> at 0x70-0x71 on isa0 sc0 not found sio0 at 0x3f8-0x3ff irq 4 on isa0 sio0: type 16550A sio1: reserved for low-level i/o sio1 not found struct nfssvc_sock bloated (> 256bytes) Try reducing NFS_UIDHASHSIZ struct nfsuid bloated (> 128bytes) Try unionizing the nu_nickname and nu_flag fields Timecounter "alpha" frequency 432900432 Hz Waiting 15 seconds for SCSI devices to settle isp0: driver initiated bus reset de0: enabling 100baseTX port rda4 at isp1 bus 0 target 3 lun 0 da4: <SEAGATE ST19171FC 5072> Fixed Direct Access SCSI2 device da4: 100.0MB/s transfers, Tagged Queueing Enabled da4: 8637MB (17689267 512 byte sectors: 255H 63S/T 1101C) da5 at isp1 bus 0 target 4 lun 0 da5: <SEAGATE ST19171FC 5072> Fixed Direct Access SCSI2 device da5: 100.0MB/s transfers, Tagged Queueing Enabled da5: 8637MB (17689267 512 byte sectors: 255H 63S/T 1101C) da3 at isp1 bus 0 target 2 lun 0 da3: <SEAGATE ST19171FCSUN9.0G 1178> Fixed Direct Access SCSI2 device da3: 100.0MB/s transfers, Tagged Queueing Enabled da3: 8637MB (17689267 512 byte sectors: 255H 63S/T 1101C) da2 at isp0 bus 0 target 2 lun 0 da2: <SEAGATE ST32550N 0022> Fixed Direct Access SCSI2 device da2: 20.0MB/s transfers (20.0MHz, offset 8), Tagged Queueing Enabled da2: 2047MB (4194058 512 byte sectors: 255H 63S/T 261C) da1 at isp0 bus 0 target 1 lun 0 da1: <SEAGATE ST15230W 0638> Fixed Direct Access SCSI2 device da1: 40.0MB/s transfers (20.0MHz, offset 8, 16bit), Tagged Queueing Enabled da1: 4095MB (8386733 512 byte sectors: 255H 63S/T 522C) da0 at isp0 bus 0 target 0 lun 0 da0: <IBM DORS-32160W WA6A> Fixed Direct Access SCSI2 device da0: 40.0MB/s transfers (20.0MHz, offset 8, 16bit), Tagged Queueing Enabled da0: 2063MB (4226725 512 byte sectors: 255H 63S/T 263C) ootfs is 2880 Kbyte compiled in MFS <<HANGS HERE>> To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.02.9811071206020.7469-100000>