Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 23 Dec 2016 12:01:22 -0500 (EST)
From:      doug <doug@fledge.watson.org>
To:        byrnejb@harte-lyne.ca
Cc:        freebsd-questions@freebsd.org
Subject:   Re: IP address assignments to jails using ezjail
Message-ID:  <alpine.BSF.2.20.1612231139220.77243@fledge.watson.org>
In-Reply-To: <b6c71debe36b214c620d4027ce6bec31.squirrel@webmail.harte-lyne.ca>
References:  <b6c71debe36b214c620d4027ce6bec31.squirrel@webmail.harte-lyne.ca>

next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, 22 Dec 2016, James B. Byrne via freebsd-questions wrote:

> When I created the new jail I used this invocation:
>
> ezjail-admin create -x hlldrupal 'lo1|127.0.1.1,vtnet0|192.168.216.196'
>
> Inside the host rc.conf I have this:
>
> # Cloned i/f and assigned ipv4 addr for jails
> cloned_interfaces="lo1"           # For shared jail configuration
>
> And ifconfig on the host shows this:
>
> vtnet0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST>
> metric 0 mtu 1500
>        options=80028<VLAN_MTU,JUMBO_MTU,LINKSTATE>
>        ether 00:a0:98:fa:aa:b6
>        inet 216.185.71.16 netmask 0xffffff00 broadcast 216.185.71.255
>        inet 192.168.216.16 netmask 0xffffff00 broadcast 192.168.216.255
>        inet 192.168.216.196 netmask 0xffffffff broadcast 192.168.216.196
>        nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
>        media: Ethernet 10Gbase-T <full-duplex>
>        status: active
> . . .
> lo1: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
>        options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
>        inet 127.0.1.1 netmask 0xffffffff
>        nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
>        groups: lo
>
> Inside the jail ifconfig shows this:
>
> vtnet0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST>
> metric 0 mtu 1500
>        options=80028<VLAN_MTU,JUMBO_MTU,LINKSTATE>
>        ether 00:a0:98:fa:aa:b6
>        inet 192.168.216.196 netmask 0xffffffff broadcast 192.168.216.196
>        media: Ethernet 10Gbase-T <full-duplex>
>        status: active
> lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
>        options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
>        groups: lo
> lo1: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
>        options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
>        inet 127.0.1.1 netmask 0xffffffff
>        groups: lo
>
>
> All this seems to be correct and yet I cannot seem to obtain an ssh
> connection to or from the jailed instance.  ubound is running in the
> jail and seems to be working.  At least host responds to queries.
>
> root@hlldrupal:~ # host sendmail.com
> sendmail.com has address 209.246.26.25
> sendmail.com mail is handled by 10 mxa-00148501.gslb.pphosted.com.
> sendmail.com mail is handled by 20 mx2.proofpoint.com.
> sendmail.com mail is handled by 10 mxb-00148501.gslb.pphosted.com.
>
> pf is not running in the jail but sshd is:
>
> root@hlldrupal:~ # service sshd status
> sshd is running as pid 81502.
>
> root@hlldrupal:~ # service pf status
> Cannot 'status' pf. Set pf_enable to YES in /etc/rc.conf or use
> 'onestatus' instead of 'status'.
> root@hlldrupal:~ # service pf onestatus
> pf.ko is not loaded
>
>
> I note that the flag IFDISABLED is present on the host's lo1. Why?  Is
> this the source of the connectivity problem with the jail? If so then
> why does the host commend work when executed within the jail?  In any
> case I can ping the jail from without:
>
> [root@vhost04 ~ (master *%)]# ping 192.168.216.196
> PING 192.168.216.196 (192.168.216.196) 56(84) bytes of data.
> 64 bytes from 192.168.216.196: icmp_seq=1 ttl=64 time=0.647 ms
>
> I just cannot connect to that address via ssh from without nor can I
> connect ssh to any address from within the jail.
>
>
> -- 
> ***          e-Mail is NOT a SECURE channel          ***
>        Do NOT transmit sensitive data via e-Mail
> Do NOT open attachments nor follow links sent by e-Mail

The handbook suggests that getting loopback traffic is a good thing. That said 
none of our production systems do this and a number of the jails use sshguard 
via inetd. One of the original jail developers did not have a handy answer as to 
why, or if, this is a must. That said, it can't hurt.

As to pinging, the answer provided by some very helpful people here, is ping -S. 
This assumes /etc/sysctl.conf has 'security.jail.allow_raw_sockets=1' and 
/usr/local/etc/ezjail/jail-name has:

   export jail_`jail-name`_parameters="allow.raw_sockets=1"

If you read the thread [anyone know what 'ping: sendto: Can't assign 
requested" means'] it documents my rather painful acquisition of this knowledge 
:)




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?alpine.BSF.2.20.1612231139220.77243>