Date: Sun, 28 May 1995 23:27:50 -0700 (PDT) From: "Rodney W. Grimes" <rgrimes@gndrsh.aac.dev.com> To: bde@zeta.org.au (Bruce Evans) Cc: hackers@FreeBSD.org, peter@haywire.DIALix.COM Subject: Re: aargh! How to handle 128 ttys on a system? Message-ID: <199505290627.XAA00500@gndrsh.aac.dev.com> In-Reply-To: <199505290255.MAA24888@godzilla.zeta.org.au> from "Bruce Evans" at May 29, 95 12:55:12 pm
next in thread | previous in thread | raw e-mail | index | archive | help
... > >Also, the probe/attach only leaves the card in a quiescent state. I'm > >using a user mode program the uploads the firmware for the host controller > >and booting it in /etc/rc*. This step also configures the port array. > >Was there a decision made on the best place to put these during the boot > >sequence? > > No, but if serial lines are used for networking, then they must be > initialized very early, before /etc/netstart is run. This could be handled by /etc/start_if.${ifn} within /etc/netstart, it is one of the reasons that is even there. -- Rod Grimes rgrimes@gndrsh.aac.dev.com Accurate Automation Company Custom computers for FreeBSD
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199505290627.XAA00500>