Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 21 Dec 1994 21:20:16 -0800 (PST)
From:      bmk@dtr.com
To:        fcawth@squid.umd.edu (Fred Cawthorne)
Cc:        questions@freebsd.org
Subject:   Re: Strange problems with quotas >1 disk.
Message-ID:  <199412220520.VAA09318@dtr.com>
In-Reply-To: <9412222301.AA11911@squid.umd.edu> from "Fred Cawthorne" at Dec 22, 94 06:01:08 pm

next in thread | previous in thread | raw e-mail | index | archive | help

> > A few days ago I found the need to use quotas on another 
> > filesystem (/VOL2), which is on a different physical disk from
> > /VOL2 (I doubt that matters).  Since doing so, I have been plagued
> > with intermittant page faults and reboots when I run any of the
> > quota utilities.  For example, quotacheck -v -a will often cause
> > a reboot (no page fault) after it finishes checking /VOL1.  edquota
> > fails as well when it attempts to update user.quota, but it
> > SOMETIMES gives a page fault (I didn't record the information,
> > unfortunately).  Usually it just reboots.  Sometimes it even
> > works like it should :).
> > 
> ...

> > Has anyone else seen this problem, or is it just me?
> > 
> I have seen this on my system.  (Just tried it...)
> I have also seen one reboot when I was doing alot of quota changing on a
> config with only one filesystem that had quotas.
>  (i.e. edquota a bunch of times...)  It usually works correctly for 
> the single filesystem case, as you noted.  When I enabled quotas on 
> a second filesystem, and ran quotacheck, it rebooted my machine!!!!
> (I was running X, so I don't know if there was a message...)
> Also, when it came back up, and tried to check the quotas, it said:
> quotacheck: cannot allocate memory
> (When quotacheck -a was run from the rc file)
> I have 32 megs of ram, 64 megs of swap ... What gives????

I had forgotten about this symptom... Mine did this also.   I have 32MB of
ram and 128MB of swap.  It's virtually impossible that I was out of memory
unless quotacheck is leaking like a sieve.

If I was to take a WAG about where the problem is, I'd start looking in the
kernel quota routines... But then again, I'm not a kernel hacker. :)




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199412220520.VAA09318>