Date: Wed, 21 Feb 96 19:27:36 EST From: Trevor Mendez <tmendez@BBN.COM> To: freebsd-hardware@freebsd.org Cc: tmendez@BBN.COM Subject: Net Install with 3c589 (PCMCIA) Message-ID: <199602220031.QAA13872@freefall.freebsd.org>
next in thread | raw e-mail | index | archive | help
* Attempting to load FreeBSD 2.1 over the Net onto a IBM ThinkPad using a 3Com EtherLink III ethernet card (3c589). * Successfully made a boot disk with image from the ftp site. * Everything worked except that after about 20 attempts, the device is never attached -- it is recognized as being in slot 1, but the probe to the I/O address fails, resulting in "zp0 not found at 0x300". * I have used tried using 3com software to set the device's I/O port and INT# to the ones used by the kernel. And I have set the numbers on the card and in the kernel (booting with "-c") to several other pairs of numbers without success. Is there something else that I should try? Thanks.` /tdm
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199602220031.QAA13872>